|
| |
 |
The 1 Pound Pressure Pot
(shown
left, front left) is useful for a variety of fluids, especially
Cyanoacrylates.
1 lb. bottles are
most common size for packaging CA. Side slit allows monitoring fluid levels without
opening. For UV, or light sensitive
fluids, choose the
1 Liter Pressure Pot, (shown
left, back right) which does not have side slit.
|
|
Also in this Category:
1 LB Pressure Pot
1 Liter Pot
2 Liter Pot
1 Gallon Pot
2 Gallon Pot
5/10 Gallon Pot
Other Valves
You may also be
interested in:
Dispensers
Valve Controller
Dispense Valves
Reservoirs
Robot
Platform
Also of interest;
Precision Needles
Needle Nozzles
Thin Wall tips
Dispensing
Help
Doming & Potting
Solder Dispensing
|
|
To feed any IDS valve, choose from our
dispensing syringes, (to feed thin to medium materials in very small
shots)
our
single cartridges,
(for medium to thicker materials in smaller shots or beads)
or for large
volume capacity, order one of our
reservoirs (for thin to medium
materials)
or one of our
pail
dispenser units, for thicker materials. For a typical valve
setup, click here.
Simple to use:
-
Remove
two threaded thumbscrews and lift lid.
-
Place uncapped material bottle in center of tank.
-
Return lid to top of pressure tank, assuring dip tube is positioned inside
the bottle of fluid.
-
Tighten thumbscrews.
-
Connect all material and air lines supplying pressure to the tank.
Specifications
-
Inside Dimensions:
3.25" diameter x 7.5" high
-
Overall Outside
Dimensions: 6" diameter x 9.5" high
-
Body of Tank:
Anodized Aluminum, with side viewing slit
-
Gaskets: (2) Viton®
o-rings
-
Operating Air
Pressure: 0-70 PSI
-
Air Inlet: 0.25" OD
tube quick connect fitting
-
Material Outlet:
0.125" NPT polypropylene fitting
Part # Description
7011007 - 1 LB CA Pressure Tank (Holds 500 g bottle of material)
7011008 - O-ring for tank,2 required
7011009 - Acrylic insert for tank
|
|
| |
|
